Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Colorado Springs, CO

Clopay Torsion Spring Replacement in Colorado Springs, CO

Torsion springs replaced and wound correctly, with high-cycle upgrades available. Typical cost $200-$450.

From the first phone call to the final safety test, Clopay torsion spring replacement in Colorado Springs, CO follows a simple process: diagnose, quote, repair, test. Torsion springs replaced and wound correctly, with high-cycle upgrades available. We work on Clopay garage doors of every age, from older models to current lines, and carry or can source compatible parts. Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Signs you need Clopay torsion spring replacement

  • A gap in the spring mounted on the bar above the door
  • The door slams shut or won't stay open
  • Only one side of the door lifts and the door goes crooked
  • The door is suddenly too heavy to lift by hand

What usually causes it

  • Normal fatigue at the end of the spring's rated cycles
  • Rust or lack of lubrication
  • An undersized spring working too hard
  • A door that's been made heavier with insulation or new panels

What you can check yourself

  • Count the springs above the door. Two-spring doors should have both replaced together.
  • Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
  • Note how often the door is used each day so the right cycle rating can be chosen.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our Clopay torsion spring replacement process

  1. Clamp the door and unwind the old springs with proper winding bars
  2. Measure wire size, inside diameter and length, and weigh the door
  3. Install correctly rated springs, upgrading to high-cycle if you use the door a lot
  4. Wind to the right number of turns and set the door's balance
  5. Lubricate, adjust the cables and test the full travel

Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.

Typical Clopay torsion spring replacement prices

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Clopay services

Serving Colorado Springs, CO and nearby towns

In Colorado, cold mornings after mild afternoons put the most stress on worn springs, so breaks are common in late fall and winter.

Our Clopay torsion spring replacement service covers Colorado Springs (ZIP codes 80901, 80902, 80903, 80904, 80905 and more) and nearby towns including Stratmoor (4.7 mi), Manitou Springs (5.5 mi), Fort Carson (6.9 mi) and Security-Widefield (8.3 mi). Call (833) 435-8883 to book a visit in Colorado Springs.

Clopay Torsion Spring Replacement: frequently asked questions

How much does Clopay torsion spring replacement cost in Colorado Springs, CO?

Clopay Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Clopay torsion spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Clopay torsion spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Clopay warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Colorado or Colorado Springs requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Colorado Springs, CO

Broken Garage Door Spring Repair

Fast replacement of broken torsion or extension springs, sized to your door's weight.

Typical $200-$450

Overhead Door Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Haas Door Garage Door Track Repair

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$400

Overhead Door Garage Door Roller Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$350

Moore-O-Matic Remote & Keypad Programming

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $50-$150

Overhead Door Garage Door Track Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$400

Amarr Garage Door Panel Replacement

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $300-$900

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Cornell Cookson Rolling Fire Door Inspection & Drop Testing

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $150-$500

Overhead Door Opener Circuit Board Replacement

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $175-$400

Garaga Off-Track Garage Door Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $175-$450

Midland Garage Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in Colorado Springs, CO now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote